News     Events Calendar     Photo Gallery     Subscribe     Giveaways/Contests     Advertiser Links     Contact Us
Volume 29 • Issue No. 4 •
sidebar
Current Issue
Back Issues
Kayak Fishing
River Flows
2007 Readers Survey

Subscription Service
Contributor's Guidelines
Premier Paddling Shops
Visit the ACA
Other links





Paddler News Feed
rss (1K)
 


July / August 2000

Features
Hotline
Destinations
Gear
Skills
Sea Kayaking Supplement


More from
Skills
Capsize Recovery

Return to
Table of Contents
< July / August 2000
Skills
Capsize Recovery

Kent Ford

As a sea kayaker, you need to know how to recover from a capsize quickly, so you can minimize exposure to the elements. Your goal is to be in the safety of your boat, and paddle away in a comfortable, stable manner. Even without a roll, most flips are no big deal if you are well practiced at capsize recovery options, and prepared for the water.

No amount of reading will completely prepare you for threatening situations. You have to practice! For the best success, take a class and learn some of the finer points of each capsize recovery. With each situation there are several options that work. Experimenting will help you understand which variation is appropriate for a true dilemma.

With every capsize recovery the objective is to get back in the boat and empty the water out. These two essentials happen in either order, depending on the rescue. The primary determining factor is water temperature. Cold water can rob you of strength after only a few minutes. Dress for the water temperature in case of an unexpected swim, and think through rescues that get you out of the water quickly.

Assisted Rescue

The most common assisted-rescue occurs when the rescuing paddler pulls alongside the swamped boat to stabilize it for reentry. The rescuer leans over and spans the cockpits with a paddle to immobilize the boats. Maintaining a low center of gravity makes re-entry easier. Usually this means crawling onto the boat with your chest on the rear deck. To get up on the deck, kick your feet up, so you are laying on the surface, and then pull the kayak under you.

From this low position you can slide into the cockpit, and twist into the seat. As you climb in, keep in balance by twisting toward your friend. Then put your skirt on, pump out the water, and stabilize yourself before releasing and continuing. An alternative to pumping (especially if the boat has a bulkhead to keep the rear compartment dry) is the T rescue, where the rescuer moves perpendicular to the swamped boat and lifts the bow while you push down on the stern. Once the boat is emptied, flip it rightside up again and pull it into the bow-to-stern stabilizing position for re-entry. If the swamped boat doesn't have a watertight bulkhead, it can be pulled further over the deck to drain it completely. This TX rescue takes more effort, lots of teamwork, and risks damage to the boats. Usually paddlers will choose to reenter and pump out boats that don't have a bulkhead.

If a paddler has trouble re-entering the boat, you can also make a stirrup from a loop of rope or webbing by wrapping it around the paddle to provide a welcome step for re-entry. Wrap the stirrup close to the boat, to make it secure. This stirrup can be adapted to many of the rescues.

Self Rescue

The conditions that might cause you to flip often make getting back in the boat challenging. Getting assistance with re-entry is the best option. If you flip out of range of assistance, however, a paddle float outrigger can provide extra stability. First, hang on to all your equipment. Then, you use the paddle with a paddle float to form an outrigger held perpendicular to your boat.

After the swim hook a leg into the boat. This frees both hands to attach and inflate the paddle float. This is harder than you might think. A foam paddle float is often preferred in cold regions, where cold hands and cold water make inflating a float difficult. Once the float is ready, grasp the paddle shaft and cockpit rim to form an outrigger. Then kick with your legs to plane your body out before pulling the stern deck under your chest. Rest your legs on the paddle shaft, then slide one leg in and then the other. Turning toward the paddle float will help you lean in that direction, so you can establish a balanced sitting position. At this point use your bilge pump to empty the water. Stow the pump and paddle float, then continue on your way.

By carefully flipping the boat before you re-enter, you can keep out some of the water and reduce your pumping time. This requires a snappy kick of your legs while you lift and twist the bow. Some boats have special deck rigging which simplifies a paddle float re-entry. Deck rigging also leaves your hands free to pump and attach the skirt.

Practice capsize recovery in warm water and calm conditions, so you'll gain confidence. Take a class to learn some of the finer points and get feedback on your technique. Don't underestimate how difficult it can be to maneuver into a helpful position. These rescues are harder than meets the eye, so please practice!

-Author Kent Ford produced Performance Sea Kayaking, which recently passed the 100,000 viewer mark, and recently released In the Surf! Find more tips at www.performancevideo.com.


T O P
© Paddler Magazine, 2000-2007
H O M E